The S&L Catalog
4-channel High Performance Power Amplifier
Series: X
Model: X4
- Power supply
- Advanced switch-mode power supply permitting worldwide AC acceptance and direct connection to any regional power line configuration.
- Suitable to Single Phase, Bi-Phase or Three Phase operation from 85 VAC up to 440 VAC without need of manual selection.
- True Three Phase load balancing is directly achievable by the unit without any complex load assignment in the power distribution system design.
- Power Factor Correction PFC for extremely low mains consumption and extremely wide mains operating range
Powersoft X4 innovates and evolves the concept of the amplification platform though the integration of a worldwide compatible power-box and a full feature DSP inside the power amplifier.
The complete digital audio signal management system based on ARM Cortex A-8 processor and TI C6000 DSP platform heralds new and innovative level of signal processing, providing non-boolean routing and mixing, multi-stage equalization with raised-cosine, IIR and FIR filters, delay up to 4 s in input processing and 200 ms for time alignment, gain and polarity adjustment, crossover, peak limiters, TruePower™ limiters and Active DampingControl™.
The power supply permits worldwide AC acceptance and direct connection to any regional power line configuration: it is now suitable to Single Phase, Bi-Phase or Three Phase operation from 85 VAC up to 440 VAC without need of manual selection. True Three Phase load balancing is directly achievable by the unit without any complex load assignment in the power distribution system design.
- Power supply
- Advanced switch-mode power supply permitting worldwide AC acceptance and direct connection to any regional power line configuration.
- Suitable to Single Phase, Bi-Phase or Three Phase operation from 85 VAC up to 440 VAC without need of manual selection.
- True Three Phase load balancing is directly achievable by the unit without any complex load assignment in the power distribution system design.
- Power Factor Correction PFC for extremely low mains consumption and extremely wide mains operating range
- Low Inrush Limiting reduces AC inrush current, removing the need for expensive power sequencers
Fully protected circuit design with:
- Amplifier Type - Power Amplifier
- Warranty - Yes
- Dante Enabled - Yes
- Spec Sheet available - Yes
- Operating Temperature (Maximum): 113 F
- Operating Temperature (Minimum): 32 F
- Maximum Frequency Response (Bandwidth): 30 kHz
- Maximum Frequency Response (Bandwidth): 30000 Hz
- Minimum Frequency Response (Bandwidth): 5 Hz
- Minimum Frequency Response (Bandwidth): 0.01 kHz
- Impedance: 8 ohm
- Total Harmonic Distortion + Noise (THD+N): 0.50 %
- AC Voltage (Maximum): 440 Volts
- AC Voltage (Minimum): 85 Volts
- Current Draw: 18 Amps
- Height: 1.73 in
- Width: 19.49 in
- Warranty (Length/Type): 1 Year
- Number of Channels: 4
- Number of Watts Per Channel: 1600 Watt
- Product Weight: 33.07 lbs
Suggested Products
S&L Integrated
7 Midway Road
Thomasville, GA 31757
USA
(229) 378-8866
https://slintegrated.com/